[. . . ] This product is the Waterproof Lens Port (PPO-E05) designed exclusively for use with the PT-E series of waterproof case. Underwater zooming is made possible by attaching the zoom gear, provided with this product, to the zoom ring of an applicable camera lens. Disclaimer Unauthorized copying of this manual in part or in full, except for personal use, is prohibited. [. . . ] Please note that diving in depths over 40 meters may cause irreparable damage and/or may result in water leaking into this product and the camera and lens. The maximum depth that this product can be used is 40 meters, regardless of what case it is combined with. For example, even when combined with a PT-E series case certified for 60 meters, the maximum depth is still limited to 40 meters. When sealing this product, make sure that no foreign matter is caught on the O-rings or O-ring contact surfaces. Before storing this product, always remove it from the camera and lens. To control lens zooming from this product, the provided zoom gear must be attached to the zoom ring of the lens. Correctly attach the zoom gear to the zoom ring of the lens as instructed in this manual. E-1 1 Name of Parts PPO-E05 main body Silicon O-ring (POL-E101) Front cap Rear cap Zoom gear (PPZR-E06) Grease for silicone O-ring O-ring remover 2 Mounting the PPO-E05 on the Waterproof Case Grease applying surface on O-rings Threaded section O-ring This section describes how to mount this product on the PT-E series case. Before mounting, check that no foreign matter is attached to the O-rings, the port mount thread on the PT-E series case, or the Oring contact surfaces. Apply a thin layer of the provided silicone O-ring grease. O-ring contact surfaces Port mount thread Align the threaded section of the PPO-E05 with the port mount thread on the PT-E series case. Hold the PT-E series case firmly with one hand, hold the main body of the PPO-E05 with your other hand and screw it into the PT-E series by turning the PPO-E05 clockwise. However, be sure to screw it in all the way until there is no gap visible below the threaded section of the PPO-E05. Screw in until there is no gap. E-2 3 Dismounting the PPO-E05 If any water is on the product, wipe it completely away and make sure that the product is dry. Holding the PT-E series case firmly with one hand, loosen the PPO-E05 by turning it about 90 degrees counterclockwise. If the PPO-E05 is attached too tightly to turn, wrap it with a piece of rubber or similar non-slip material. After loosening the PPO-E05, point its lens downward and turn it further counterclockwise until it is separated from the PT-E series case. [. . . ] To apply grease to each O-ring, squeeze a drop of grease about the size of a grain onto your finger and lightly rub the entire circumference of the O-ring to spread the grease thinly and evenly. E-6 6 Specifications : PT- E series : ZUIKO DIGITAL ED14-42mm F3. 5-5. 6 : Aluminum. diameter 143 mm x Depth 80 mm : 739 g (excluding the conversion lens) Applicable case Applicable lens Main materials Main body Lens window O-rings Zoom gear Front cap Rear cap Withstanding pressure Dimensions Weight Note) We reserve the right to change the external appearance and specifications without notice. 7 Consumable Items Product Model POL-E101 Product Model PSOLG- 1 Description O-ring for use with the PT-E series case. [. . . ]